OVERVIEW

Official designation: GE Fanuc IC200ALG260 (VersaMax, Analog Input Module)

Role/Application: An 8-channel, single-ended analog input module that converts configurable voltage or current field signals into digital data for the VersaMax I/O control system.

KEY SPECS SUMMARY

Power: 130 mA maximum from plus 5V bus

Interfaces / Ports: VersaMax I/O carrier connector

Indicators: Two LEDs: OK and INT PWR

Operating Temp: 0 degrees C to 60 degrees C

Platform / Compatibility: VersaMax I/O system, CPU firmware 1.20 or later

Limit: Input Impedance 200 Ohms in Current Mode

Lifecycle: Active

FREQUENTLY ASKED QUESTIONS

Technical Specifications:

Q: What is the rated update time and input filter response time for the module?

A: The module's update rate is 0.4 ms, and the input filter response time is 5.0 ms.

Wiring & Installation:

Q: What input ranges are configurable using the two jumpers on the carrier terminals?

A: Jumpers select between current mode (4 to 20 mA) or voltage mode (0 to 10 VDC or plus/minus 10 VDC).

Troubleshooting & Compatibility:

Q: What diagnostic information does the module provide besides the LED status indicators?

A: Diagnostics report under/over range, open wire, loss of power, and high/low alarm conditions.

Replacement & Upgrades:

Q: What is the continuous optical isolation rating for the user input to logic and frame ground?

A: The module provides continuous optical isolation up to 250 VAC.