OVERVIEW

Official designation: GE Fanuc IC693BEM333 (Series 90-30, Remote FIP Interface Module)

Role/Application: This communication module enables the Series 90-30 PLC to function as a slave on the Factory Instrumentation Protocol (FIP) network for high-speed, synchronized data exchange.

KEY SPECS SUMMARY

Power: Supplied by 5 VDC backplane

Interfaces / Ports: Two 9-pin D-type serial ports

Indicators: Four status LEDs (CD1, TEN1, CD2, TEN2)

Operating Temp: 0 degrees C to 60 degrees C

Platform / Compatibility: Series 90-30 PLC; not RX3i compatible

Limit: Transmission speed of 1 MHz

Lifecycle: Discontinued

FREQUENTLY ASKED QUESTIONS

Technical Specifications:

Q: What is the primary communication protocol supported by the IC693BEM333 module?

A: The module supports the Factory Instrumentation Protocol (FIP) for industrial networking and data exchange.

Wiring & Installation:

Q: What is the required power installation procedure for the IC693BEM333 module?

A: Power must be disconnected from the rack prior to installation, as the module does not support hot-swap capabilities.

Troubleshooting & Compatibility:

Q: What do the CD1 and TEN1 LED indicators typically signify on the FIP interface module?

A: These indicators often represent Carrier Detect and Transmitter Enable status for the respective communication port.

Replacement & Upgrades:

Q: Can the IC693BEM333 module be used on the universal backplane or with a Series RX3i system?

A: No, this module is limited to the Series 90-30 PLC backplane and is not compatible with RX3i systems.