OVERVIEW

Official designation: GE Fanuc IC693BEM330 (Series 90-30, FIP Remote I/O Scanner Module)

Role/Application: This FIP I/O Scanner module interfaces the Series 90-30 PLC to a Factory Instrumentation Protocol bus for distributed control and remote I/O data exchange at 1 Mbit per second.

KEY SPECS SUMMARY

Power: 5 VDC, 609 mA

Interfaces / Ports: Two 9-pin male D-shell connectors

Indicators: CD1, TEN1, CD2, TEN2 status LEDs

Operating Temp: 0 degrees C to 60 degrees C

Platform / Compatibility: Universal Series 90-30 baseplates

Limit: Supports up to 19 I/O modules remotely

Lifecycle: Discontinued

FREQUENTLY ASKED QUESTIONS

Technical Specifications:

Q: What is the maximum data rate and communication protocol used by the BEM330 module?

A: The module operates at a 1 Mbit/second data rate using the FIP and World FIP protocols.

Wiring & Installation:

Q: Which connector type is required for termination of the FIP synchronization cable on this module?

A: A separate SYNCHRO port, requiring a Molex connector with catalog number 39-01-4031, is used for termination.

Troubleshooting & Compatibility:

Q: What do the CD1 and TEN2 LED indicators on the module signify during operation?

A: CD1 and CD2 indicate Carrier Detection status, while TEN1 and TEN2 indicate Transmission Enabled status for each FIP channel.

Replacement & Upgrades:

Q: Can the IC693BEM330 module be used in a PACSystems RX3i Universal Backplane?

A: No, the IC693BEM330 module cannot be included in a PACSystems RX3i Universal Backplane.