OVERVIEW

Official designation: GE Fanuc IC695PBS301 (RX3i PACSystems, PROFIBUS Slave Module)

Role/Application: A single-slot communication module for the RX3i platform, enabling it to function as a PROFIBUS DP-V0 and DP-V1 Slave for high-speed, distributed automation networks.

KEY SPECS SUMMARY

Power: 440 mA at 3.3 VDC

Interfaces / Ports: 9-pin D-sub female connector

Indicators: PROFIBUS OK, NETWORK, MOD STATUS

Operating Temp: 0 to 60 degrees C

Platform / Compatibility: Universal RX3i backplane

Limit: 244 bytes Input and 244 bytes Output

Lifecycle: Active

FREQUENTLY ASKED QUESTIONS

Technical Specifications:

Q: Does the IC695PBS301 module support the full range of PROFIBUS DP communication data rates?

A: Yes, the module supports all standard data rates from 9.6 Kbit/s up to 12 MBit/s.

Wiring & Installation:

Q: What is the required connector type for the PROFIBUS network connection on this module?

A: The module uses a standard 9-pin D-sub female connector for connection to a PROFIBUS bus terminal.

Troubleshooting & Compatibility:

Q: How can firmware updates be performed on the PROFIBUS Slave module?

A: Firmware updates are performed indirectly by the host CPU using the WinLoader software utility.

Replacement & Upgrades:

Q: What is the minimum CPU firmware revision required for the IC695PBS301 module to operate?

A: The PROFIBUS Slave module requires an RX3i CPU with a minimum firmware version of 3.0 or later.