OVERVIEW

Official designation: GE Fanuc IC694DSM314 (PACSystems RX3i, Motion Controller Module)

Role/Application: A high-performance motion control module for the RX3i platform, supporting 1-2 axes of digital servo or 1-4 axes of analog servo for precise synchronized multi-axis coordination.

KEY SPECS SUMMARY

Power: 800 mA at +5 VDC (plus encoder supply current)

Interfaces / Ports: Fiber Optic to amplifiers, serial programming port

Indicators: Seven status LEDs including STAT

Operating Temp: 0 to 60 degrees C

Platform / Compatibility: RX3i Universal Backplane, Any IC694 CPU

Limit: 1 slot occupied; 10 stored programs

Lifecycle: Active

FREQUENTLY ASKED QUESTIONS

Technical Specifications:

Q: What are the two supported control loop configurations on the DSM314 module?

A: The module supports Standard Mode (Follower Control Loop Disabled) and Follower Mode (Follower Control Loop Enabled).

Wiring & Installation:

Q: What critical physical connection is required for proper installation and noise reduction?

A: The IC694DSM314 must be connected to the system frame ground via the dedicated terminal on its bottom.

Troubleshooting & Compatibility:

Q: What do the slow and rapid blinking of the STAT LED indicate about the motion controller status?

A: Slow blinking signifies a non-stopping status error, while rapid blinking indicates an error that will halt servo operation.

Replacement & Upgrades:

Q: Which GE Fanuc servo amplifier series are compatible with the IC694DSM314 motion module?

A: The module is compatible with GE Fanuc Alpha Series and Beta Series digital servo amplifiers and motors.